Other Tips On The Safety of Burning Backflow Incense ConesĪs mentioned previously, incense is a natural fire hazard. You will have to throw away the remnants and use a new one next time. However, once you do this, the cone cannot be reused again. You can also manually put out a burning backflow incense cones by immersing the burner in water. Normally, incenses extinguish themselves once they finish burning. How to Correctly Put Out A Backflow Incense Cone? If they are not aligned properly, there will be no smoke coming out of the burner. Ensure that the hole at the bottom of the cone aligns with the hole in the burner. If there is no ember nor any smoke, you should repeat the steps above again.ģ,Place the burning cone into a backflow incense burner. If you are unsure whether it is working, wait and watch for a minute or so. This means that the backflow incense cone has been lit up properly. You should see glowing ember at the tip of the cone as well as smoke exiting the hole on the bottom. ![]() ![]() If the flame dissipates quickly, repeat the process again.Ģ,Once the cone starts burning, wait about 4 to 8 seconds before gently blowing out the flame. It may be slightly more difficult to maintain the flame of the cone compared to a stick. Wait until the cone ignites with a small flame. Make sure that the incense cone comes into full contact with the burning flame. Follow the steps below:ġ,Hold the cone in one hand and light the pointy end using a match or lighter with your other hand. It is very important to light incense in a safe way to minimize the risk of fires. How to Use Incense Cones with The Right Way? There are special incense burners designed to look like a pot pouring hot tea, a dragon breathing smoke, a castle shrouded in mysterious fog, or a cascading waterfall surrounded by light mist.Īnother advantage of this type of incense is that it leaves behind ashes in a nice and tidy pile whereas a stick incense tends to drop ashes all around it. The downward flow of incense plume creates mesmerizing scenery that is unique to backflow incense cones when lit in a burner. Smoke produced from a backflow incense cone is forced into the central tunnel and is gradually cooled during its travel therefore, the incense smoke remains heavier than room-temperature air and continues to gently flow downwards like fog or water. When a stick incense is lit up, even though incense plume contains small particles from the burning material, smoke still rises because hot air is lighter than the surrounding air. A backflow incense cone, however, directs smoke downwards through a small, hollow tunnel through the center, allowing the plume to escape from the hole at the bottom. Normally, when a stick incense is burned, the smoke travels upwards. There are several types of incenses on the market, including stick incenses, coil incenses and cone incenses. They were originally used in religious rituals, but now people around the world have been burning incenses for relaxation, meditation or to counteract disagreeable odours. The words incense cones are derived from the Latin word to burn.Most materials are plant-based, often including a variety of resins, barks, seeds, and flowers. Today we will share how to use incense cones here. ![]() ![]() They are typically made up of aromatic material that gives off a fragrant scent when being burnt. Incense has been around since ancient times.
0 Comments
Leave a Reply. |